www.bhdu.cn-夜肉伦伦影院无码 ,国产精品www夜色视频,3d动漫精品啪啪一区二区免费,久久婷婷综合缴情亚洲狠狠

1.Fundamental Requirements for Die Design Checking
將進行三輪模具設計校核:
1.1 The service supplier will carry out three rounds of die design checking:
模具設計校核基本要求
1. Cast check, 檢查
2. Steel check 鋼檢查
3. Final check 最后檢查
For each round the supplier need check the die design for adherence
對于每一輪，需要檢查模具設計是否符合要求。
? to the die manufacturing approval protocol MAP (FAP), which defines the materials to be used, etc. at the end of the method planning period.
對模具制造批準協議MAP (FAP)，在方法規(guī)劃期結束時定義要使用的材料等。
? to the requirements of Press-line and flow chart (DLP).
符合壓線和流程圖(DLP)的要求
? to warrant functionality and avoid collision risks in the die design.
保證模具設計的功能性并避免碰撞風險。
? to casting die design requirements (breakage, metal flow, etc.)
?符合鑄造模具設計要求(破損，金屬流動等)
1.2 The verification of the die design will be based on a check list (DSCL) provided by VWA. The issues found shall be documented with pictures (screen shots) with an explanation using a VWA template. Recommendation to solve the issues shall be included (example: increase casting width, optimization of functionality, etc.)
模具設計的驗證將基于VWA提供的檢查表(DSCL)。發(fā)現的問題應以圖片(屏幕截圖)
記錄，并使用VWA模板進行解釋。應包括解決問題的建議(例如:增加鑄件寬度，優(yōu)
化功能等)
The results of the die design check might need to be discussed with VWA and the die manufacturer.
模具設計檢查的結果需要與VWA和模具制造商進行討論。